Neutrik NPPA-TT-S PATCH PANEL “Easy Patch” - Manual (Page 10)

Page 10 of 13
NPPA-TT-S Instruction Manual
7. Channel identification
The front panel is equipped with channel identification strips located in the center of the
channels and marked with the channel numbers 1-24 and 25-48 respectively.
Channel identification strips Labeling strips
For the perfect management of the system and for individual identification according to
customer’s needs there are two large and separate labeling strips, one for the bottom and one
for the top row.
To write on the paper you have to unscrew one of the outer fixing screws of the front panel.
Then pull out the side-stop, the transparent foil and the paper strip itself.
After marking is done assemble the parts in reversed sequence.
Remove labeling strip Side Stop
NOTE: For easy and perfect marking you can use our designation software “PatchLabel”
which is available on our web site
www.neutrik.com free of charge.