Swanstone STMK72-3662 - Installation - Manual (Page 17)

Attaching Shower Doors and Accessories
1. Follow the mounting instructions that come with each
accessory.
2. Drill pilot holes, where fasteners pass through the wall
panels, slightly larger than the fastener.
3. If anchors are being used, drill the hole in the panel large
enough for the head of the anchor to fit through the panel
and the structural wall behind it.
4. Use 100% clear silicone to seal any holes or joints
between the accessory and the wall panel.
Care and Cleaning
Swan Corporation Veritek products are stain and abrasion
resistant; however, the finish requires reasonable care.
Because cleaning products change over time, always check
the manufacturer’s instructions to make sure it is compatible
with solid surface acrylic or with fiberglass reinforced
polyester. DO NOT use a cleaner if the label indicates it
should not be used on solid surface acrylics or fiberglass
reinforced polyester. DO NOT use spray-on cleaners that
require daily use without immediately rinsing with water to
stop the chemical cleaning reaction because damage will
result and void the warranty.
Day-To-Day Cleanup
Simply wipe the surfaces with a clean towel to remove
watermarks and residues. All Swanstone products can be
cleaned with warm water, a soft cloth, and normal household
detergents or cleansers, such as Fantastic, Formula 409,
Clorox Clean-up, Handy Andy, Mr. Clean, Dow Scrubbing
Bubbles, Lysol Foaming Tub and Tile Cleaner, Top Job, or
Lestoil. Always rinse off cleaners within five minutes of
application.
Occasional scrubbing with household abrasive cleaners
ensures that the original luster is maintained.
Caulking Joints
Inspect caulking joints monthly for damage or any signs of
separation from the mating surface. Cracks in the caulking will
allow water to leak into the surrounding surfaces. Reapply
caulking to any joint showing signs of wear or cracking.
Failure to inspect and repair caulking joints will void the
warranty.
IMPORTANT NOTICE
800-325-7008 17 The Swan Corporation
Installation Procedure Maintenance & Cleaning