Swanstone SS-7211 - Installation - Manual (Page 5)

2. After marking the height, draw a 4” level-line on both
walls. These lines will be used to align the top edges of
the soap dish.
Dust Hazard
When cutting or drilling the Swanstone
product, use a dust collection method which
prevents dust particles from going into the air. Always
work in a well-ventilated area. Always use an OSHA
approved dust mask when cutting, drilling, or sanding
Swanstone products.
3. Dry fit the soap dish prior to applying clear silicone. The
soap dish may require sanding to fit precisely in the
corner. The actual angle of the soap dish is slightly
greater than 90 degrees to accommodate some
adjustment. If necessary, mark and sand the side(s) of
the soap dish to achieve a proper fit, using a course grit
(60 grit) sandpaper.
4. Apply clear silicone to the edge of the soap dish.
5. Align the soap dish with the level-lines and press it into
place.
6. Hold the soap dish securely in place and wipe off excess
clear silicone. You will want a uniform bead on both top
and bottom.
7. Temporarily secure the soap dish with masking tape, as
shown. Remove the tape after approximately two hours.
Do not place anything on the soap dish for at least 24
hours.
WARNING
800-325-7008 5 The Swan Corporation – Swanstone
Installation Procedure