Derale Performance 40 Row Hyper-Cool Extreme Remote Cooler, -8AN - Manual

15870-InstructionSheet
Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
INSTALLATION INSTRUCTIONS
HYPER-COOL REMOTE COOLER
PART # 15870
KIT CONTENTS
QTY. DESCRIPTION
1 Oil Cooler Assembly
2 -8AN x 7/8” Male Adapter
Please read these instructions completely before starting the installation.
This fan assembly is designed for PULLER
(engine side) applications only.
The AN fittings supplied in this kit do not require any thread
sealant. (See Diagram #1)
7/16” Socket & Ratchet
Open End Wrench’s
Marker Drill
9/32” Drill Bit
TOOLS NEEDED
Warning: Installation of accessories should only be undertaken by those with mechanical knowledge and are familiar with working on
vehicles. Always use eye protection (goggles, safety glasses or shield). Park the vehicle in a well lit area, on level ground and apply the
parking brake. Only work on a cold vehicle that has been sitting overnight, failure to do so will result in severe burns and injury. Before starting
the vehicle, make sure no tools or any other items are left under hood that could interfere with or be drawn into moving parts of the engine.
Failure to follow instructions can lead to severe damage and personal injury.
WIRING (See Diagram # )
9.2 Amps
Hook the Positive (+) Blue wire to a switched 12 volt source (Manual Switch or
Thermostat).
Hook the Negative (-) Black wire to a good chassis Ground (-).
2
Specifications- Electric Fan rating:
Transmission
Engine Oil
RECOMMENDED FOR
COOLER LOCATION
COOLER INSTALLATION
The purpose of a remote mount cooler is to be able to mount the
cooler away from the front of the vehicle therefore not blocking
airflow to the radiator/condenser. This cooler can be mounted
anywhere space permits. Always keep in mind that the cooler still
needs access to airflow to perform at its peak.
(MOUNTING HARDWARE NOT
INCLUDED)
1. Identify the two -8AN x 7/8” Male Adapters.
2. Install the fittings onto the cooler with the o-ring side toward the
cooler. Thread sealant is not necessary on o-ring fittings.
3. Using a 1 1/8” Open End Wrench, tighten fittings.
4. Hold the Oil Cooler Assembly in the desired location.
5. Using a marker, mark the four hole locations.
6. Using a drill and 9/32” drill bit, drill the four mounting holes.
7. Using 1/4”-20 Bolts, 1/4” Washers & 1/4” Lock Nuts (Not
Supplied) attach the Oil Cooler Assembly.
Note:
ROUTING HOSES
Note:
Warning:
Important:
The Cooler core will flow in either direction, there is no specified inlet or outlet port.
When routing hoses, be sure to keep all hoses away from sharp edges, moving parts and hot engine components.
Hoses should be routed carefully and should not be bent in less than a 5” radius.
A kinked hose will restrict flow and could cause failure.
IMPORTANT
Inlet
Ground
Diagram #2 Diagram #2
12V
Positive (+)
-8AN x 7/8”
Male Adapter
Diagram #1 Diagram #1
WARNING:
DO NOT OVERTIGHTEN