Derale Performance 2 Pass 24" Heat Sink Cooler - Manual

13260-13261-13262-13267-HeatSinkInstructions
APPLICATIONS:
COOLER LOCATION
MOUNTING
HOSE BARB INSTALLATION
SYSTEM CHECK
Transmission Oil
Engine Oil
Power Steering Fluid
Fuel
Oil and Fuel applications require the purchase of the proper OEM Spec hose.
This cooler can be mounted anywhere space permits. When selecting the best location for your vehicle, always consider a
location that will deliver the maximum airflow to the cooler.
1. Holding the cooler in place use a marker to identify the four mounting hole locations.
2. Using a drill and 9/32” drill bit, drill the four mounting holes in the desired location.
3. Using 1/4-20 Bolts, Washers & Lock Nuts (Not Included), install cooler.
1. Using Teflon Tape or a suitable sealant, screw the Hose Barb Fittings into the cooler until snug.
2. Using a wrench tighten the two Hose Barb Fittings.
1. Derale Heat Sink Coolers add a minimum of 1 quart of fluid to your system. Always add a quart of fluid after installation
before starting the vehicle.
2. Always check fluid levels on a flat surface.
3. After installation and vehicle has completely warmed up, check all connections for leaks.
IMPORTANT:
KIT CONTENTS
Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
Warning: Installation of accessories should only be undertaken by those with mechanical knowledge and are familiar with working on
vehicles. Always use eye protection (goggles, safety glasses or shield). Park the vehicle in a well lit area, on level ground and apply the
parking brake. Only work on a cold vehicle that has been sitting overnight, failure to do so will result in severe burns and injury. Before starting
the vehicle, make sure no tools or any other items are left under hood that could interfere with or be drawn into moving parts of the engine.
Failure to follow instructions can lead to severe damage and personal injury.
INSTALLATION INSTRUCTIONS
DUAL PASS HEAT SINK COOLER
PART # 13260, 13261, 13262, 13267
QTY. DESCRIPTION
1 Heat Sink Cooler – 1/4” NPT
2 1/4” NPT x 3/8” Hose Barb Fitting
TYPICAL TRANSMISSION INSTALLATION
Trans.
HOT
COOL
Please read these instructions completely
before beginning installation