Derale Performance 6 Pass 13" Dyno Cool Series 6000 Aluminum Transmission Cooler - Manual

KIT CONTENTS
QTY. DESCRIPTION
1 Transmission Cooler
1 11/32” X 4’ Hose
4 Hose Clamps
1 Insta-dapt Adapter
Please read these instructions completely before starting the installation.
12901-12907-InstructionSheet
TOOLS NEEDED
Standard Screw Driver or 5/16” Nut Driver
Dyke Pliers
Razor Knife
5/8” Open End Wrench
QTY. DESCRIPTION
4 Mounting Rods
4 Mounting Clips
4 Foam Pads 1x1
INSTALLATION INSTRUCTIONS
TRANSMISSION COOLER
PART # 12901-12907
Dyno-Cool by Derale, Los Angeles, CA 800.421.6288 www.derale.com
(Continues on Page 2)
The Transmission Cooler can be mounted in multiple locations on your
vehicle. Reference Diagram # 2 for possible cooler positions. #1 is the
ideal location, #2 is second best and #4 being the last choice.
The Cooler core will flow in either direction, there is no specified inlet
or outlet port.
Note:
Diagram #2
COOLER INSTALLATION
(See Diagram #3)
1. Identify the 4 Mounting Rods, 4 Mounting Clips and 4 1x1 Foam
Pads.
2. One by one, Install the 4 Mounting Rods thru the Transmission
Cooler.
3. Take the 1x1 Foam Pads supplied, peel off the paper lining slide
them onto the Mounting Rods, sticking them against the
Cooler.
4. Take the Cooler Assembly with attached looped hose and hold in
the desired location.
5. Install the 4 Mounting Rods thru the Radiator/Condenser core.
Do not use excessive force when pushing the Mounting
Rods through the Radiator/Condenser. Excessive force could
cause damage to the fins and possibly puncture a tube.
6. Take the Mounting Clips supplied, making sure they are in the
correct direction (Derale writing out) install onto the Mounting Rods
and cinch them until the 1x1 Foam Pads are slightly compressed.
7. Cut off any excess Mounting Rods.
Mounting
Warning:
&
Transmission
COOLER LOCATION
When selecting the best location for your vehicle, always consider a
location that will deliver the maximum airflow.
PRE-INSTALLATION
ecure in place using the Hose Clamps.
1. Identify the and Hose Clamps.
2. Slide one hose clamp on each end of the supplied Hose.
3. Using a dab of oil, lubricate each end of the hose and install hose onto the
cooler inlets forming a loop.
4. S
11/32” X 4’ Hose
This kit includes an Insta-dapt Adapter fitting for adapting the cooler
line to the radiator. (See Diagram #1)
The Insta-dapt fitting has a 1/2”-20 Male/Female thread and fits most
vehicles with 5/16” transmission cooler lines.
For vehicles that are not compatible with the Insta-dapt Adapter, please
reference Radiator Adapter Fitting Guide included.
IMPORTANT
Insta-dapt Adapter
Diagram #1
Diagram #3
Mounting
Rods
Foam Pads
Mounting
Clips
4’ Hose