Prokit's Industries MT-1132 - Manual (Page 8)

DC CURRENT MEASUREMENT
1. Connect the red test lead to the "V
ΩmA
" jack and the
black test lead to "COM" jack. (For measurements between
200mA and 10A, remove red test lead to "10A" jack.)
2. Set the function selector to the desired DCA position.
3. Open the circuit in which the current is to be measured, and
connect test leads in series with the circuit.
4. Read current value on LCD display along with the polarity of
red test lead connection.
AC VOLTAGE MEASUREMENT
1. Connect the red test lead to "V
ΩmA
" jack and the black
test lead to the "COM" jack.
2. Set the function selector to the desired ACV position.
3. Connect test leads across the source or load being measured.
4. Read voltage value on the LCD display.
RESISTANCE MEASUREMENT
1. Connect the red test lead to "V
ΩmA
" jack and black test
lead to the "COM" jack. (The polarity of red test lead is positive
"+".)
2. Set the function selector at desired "Ω" range position.
3. Connect test leads across the resistor to be measured and
read LCD display.
4. If the resistance being measured is connected to a circuit, turn
the power off and discharge all capacitors before applying test
probes.
7