Prokit's Industries PT-1080 - Manual (Page 8)

Initial operation
Insertion and Removal of Rechargeable Battery
Ensuring the correct orientation between the battery and the
battery compartment, insert the rechargeable battery into the
machine. Do not apply force when inserting the battery.
Insertion can be achieved easily and without resistance. The
battery must be inserted completely until the battery retention
clips on the sides of the battery compartment automatically
lock it into place. To remove the battery press the battery
retention clips and pull the battery out of its compartment.
Charging the Battery Pack:
The rechargeable battery must be charged before the first use.
Only recharge the battery once it is has been fully discharged,
i.e. the performance clearly decreases.
Otherwise the battery may not achieve its full capacity at the
subsequent charge.
1) Firmly insert battery pack into charger base.
2) Connect battery charger to charger base.
3) Plug the battery charger to power source (230V/50Hz).
The red light and green light will come on when unit is
plugged in and during the battery pack is being charged, both the red light and green
light is on.
4) When the battery is full charged, only the green light will be lighted on, and the red
light will off.
Working status Battery Red Green
Not Insert Off On Plug connected
into the socket
Insert On On
Under charging Insert On On
Fully charged Insert Off On
Important! Only use the provided battery charger for charging the battery. First place the
rechargeable battery into the charging slot in the charger and then connect the charger to
the mains. Charging starts automatically.
Remove the battery from the charge after about 5 hours. Always disconnect the charger
from the mains before you remove the battery from the charger.
7