Battery check – Prokit's Industries MT-2018 User Manual

Page 11

Text mode
Original mode

Battery Check

1. This meter can come with two separate battery check ranges

to test either DC 1.5V or 9V batteries.

2. Set the selector switch to the appropriate BATT range to be

used.

3. Connect the BLACK test lead to the “-COM” jack and the

RED test lead to the Red “+” jack.

4. Connect the Red test lead to the positive end of battery and

the Black one to the negative end of the battery to be
measured.

5. Take reading on the “BATT” scale and check it good or bad

as per which portion indicated.
(Note: the mark section of “?” shows that the battery may be
starting to decay.)

Note: If connected incorrectly with the voltage, quickly
remove the test leads from the circuit as to avoid the damage
to this tester.
(This tester can afford the voltage <250V DC/AC rms. for the
period of 5 seconds max.)