Knape&Vogt BYP-60SW Series - Manual (Page 2)

Hmax = Door Height + 2-1/16" • Hmin = Door Height + 1-5/8"
1/2"
(1,3 cm)
1-3/16"
(3 cm)
1
2
3
PREPARE OPENING
MOUNT FRAME HARDWARE
• Center track in opening.
• Using track as template, mark
screw locations.
• Drill 3/32" pilot holes and
secure with (#8 x 1-1/4") screws.
• Place carriers on top of each
door at the distance shown
from the outside edge.
• Using brackets as a template,
drill 3/32" diameter holes and
secure with (#8 x 3/4") screws.
• Drill 7/8" diameter hole approximately
1/4" deep on outside edge of each door
as shown to mount pulls.
Note: If necessary, track may be
cut with a fine tooth saw.
MOUNT DOOR HARDWARE
2-Door Width = 2 x Door Width - 1"
3-Door Width = 3 x Door Width - 2"
SLIDING DOOR HARDWARE - BY PASS
Assembly
Instructions
#310300_B (1112)
3/8" - 1/2"
(1 cm - 1,3 cm)
1-1/4" - 1-9/16"
(3,2 cm - 4 cm)
2" (5,1 cm)
36"
(91,4 cm)
Opening Height
Hauteur Ouverture
Altura Abertura
Door Height
Hauteur Porte
Altura Puerta
Left Edge
Bord gauche
Borde izquierdo
Right Edge
Bord droit
Borde derecho
3-7/16"
(8,7 cm)