Peerless-AV PANA-85CEIL - Installation - Manual (Page 3)

3 of 4 ISSUED: 12-18-09 SHEET #: 125-9092-4 03-24-11
Secure two M5 x 8 mm phillips screws ( G) to ends of cross support tube (B) as shown below.
Secure tilt brackets ( A) to cross support tube (B) using four M8 x 16 mm phillips screws (F), 5/16 split washers (L),
and 5/16 flat washers ( M) in desired tilt position as shown in fig. 2.1 and 2.2.
Once tilt is established secure two end caps ( C) to cross support tube (B).
2
3
C
A
A
L
M
F
5°
10° 15°
20°
G
B
Fig. 2.1
Fig. 2.2
B
A