Warning, Hj,k – Peerless-AV ECMU-04-C-S - Installation User Manual

Page 7

7 of 32

ISSUED: 06-22-10 SHEET #: 061-9054-6 01-15-11

All other brand and product names are trademarks or registered trademarks of their respective owners.

DETAIL 3

ﬁ g 8.1

IncreLok™

TILT

SCREW

TILT

POSITION

HOLES

LOCATOR

HOLE

LOCKING

SCREW

Mounting Screen: Hook tilt brackets (J,K) onto
adapter plate (H) and swing screen in as shown
in ﬁ g. 7.1. NOTE: If the security clip does not
clear the bottom of the adapter plate, loosen the
security screw with allen wrench (L). Tilt bracket
hooks must fully engage adapter plate as shown in
detail 1. Tighten security screw using allen wrench
(L) until security clip sits ﬁ rmly against bottom of
adapter plate.
NOTE: Be sure security clip is secured to bottom
of adapter plate as shown in detail 2.

Removing Screen: Loosen security screw from
security clip until the screen is able to swing freely,
and lift screen off of mount.

Screen Adjustment: Screen can be adjusted
horizontally by loosening security screw three full
turns using allen wrench (L). Adjust screen as
shown in ﬁ gure 7.2. Tighten security screw.

NOTE: Choosing and setting tilt position may be
easier before placing screen onto wall mount.

INCRELOK™: The screen can be locked into a
pre-set tilt position of -5°, 0°, 5°, 10° or 15°. Use
locator hole to ﬁ nd tilt position hole and tilt screen
to align holes. Tighten IncreLok™ tilt screws on
both tilt brackets as shown in detail 3.

Tighten locking screw to lock down tilt position.

Mounting and Removing Flat Panel Screen

Adjusting the Tilt Angle of the Flat Panel
Screen

J,K

ﬁ g 7.2

ﬁ g 7.1

DETAIL 1

SECURITY

SCREW

SECURITY

CLIP

DETAIL 2

• Always use an assistant or mechanical lifting equip-

ment to safely lift and position the ﬂ at panel screen.

• Do not tighten screws with excessive force.

Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.

• Be careful not to pinch ﬁ ngers when pushing screen

from the bottom.

WARNING