Peerless-AV PLAV70-UNLP - Installation - Manual (Page 10)

10 of 14 ISSUED: 06-05-06 SHEET #: 202-9142-9 (2013-10-01)
Note: "X" dimensions should be equal.
• Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening can
cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to screen or product may fail.
WARNING
Installing Adapter Brackets
To prevent scratching the screen, set a cloth on a fl at, level surface that will support the weight of the screen. Place
screen face side down. Refer to screen manufacturers instructions or customer service, for removing any knobs,
base, cover, or screw(s) on the back of the screen to prepare mounting. These need to be removed to allow the
adapter brackets to be attached. Select the small, medium, large or extra large screws from the baffl ed fastener
pack then attach adapter brackets (BB) to screen following fi gure 7.1 or 7.2.
NOTE: Top and bottom mounting holes on screen must be used for attaching brackets. Verify that all holes are
properly aligned, and then tighten screws using a phillips screwdriver.
BB
CENTER
BRACKETS
VERTICALLY
ON BACK OF
SCREEN
X
X
NOTE: For fl at back screens proceed to step 7-1. For bump-out or recessed back screen skip to step 7-2.
MEDIUM HOLE FOR M5 SCREWS
LARGE HOLE FOR M6 SCREWS
Notes:
• The number of fasteners used will vary, depending upon
the type of screen.
• Multi-washers and spacers may not be used, depending
upon the type of screen.
• Use the corresponding hole in the multi- washer that
matches your screw size as shown.
MULTI-WASHER
7