Peerless-AV SA761PU-AW - Installation - Manual (Page 14)

14 of 53 ISSUED: 03-06-12 SHEET #: 095-9385-3 10-18-13
FOR PORTRAIT OR LANDSCAPE SCREEN ORIENTATION: Remove two M5 x 12mm screws and rotation block
from top of tilt head as shown in top view and rear view. Gently grasp sides of screen and rotate screen into portrait
or landscape position as shown in fi gure 6.1 then reinstall rotation block with two M5 x 12mm screws.
Adjustment of Flat Panel Screen
6
fi g. 6.1
TILT Adjustment: Adjust tension knob on side of
mount to desired tension to enable tilt adjustment
and balance your screen size and weight. Push
or pull from top or bottom of screen to adjust tilt
as shown. The tilt can be adjusted to a maximum
of 10° forward or 5° backward. Retighten tension
knob. NOTE: For larger displays, tension screw on
opposite side of mount may need to be tightened
using 5/32" allen wrench (L).
ROLL Adjustment: Rotate screen 5° clockwise or
counter-clockwise, level screen then tighten
M5 x 10mm screws as shown in detail 2.
FOR VERTICAL HEIGHT ADJUSTMENT: Tighten
or loosen M8 x 40mm screws to achieve ± 1" of
vertical height adjustment as shown in detail 2.
NOTE: M8 x 40mm screws must be turned an equal
number of times.
7
• Do not tighten screws with excessive force.
• Be careful not to pinch fi ngers when opening and
closing mount from the wall.
CAUTION
TENSION
KNOB
DETAIL 2
M5 X 10MM SCREWS
M8 X 40MM
SCREWS
• M10 x 15mm screws (E) must be securly tightened before changing orientation of wall arm assembly (A). Failure to
lock adapter bracket can cause screen to come off of mount.
WARNING
M5 X 12MM SCREWS
TOP VIEW
ROTATION BLOCK
REAR VIEW
M5 X 12MM SCREWS
ROTATION BLOCK