Peerless-AV HDS-OWK-200 - Installation - Manual (Page 12)

12 of 22 ISSUED: 08-24-12 SHEET #: 180-9029-2 10-30-12
6-2
DISPLAY
BRACKET
G
A
K
H
G
H
F
fi g. 6.3
fi g. 6.4
fi g. 6.5
Slide universal adapter bracket to the side to expopse the display bracket mounting slots. Attach the mounting
brackets (K), open end of notch facing downward, to the left display bracket with two 1/4-20 x 1/2 socket head
screws (G) and two 1/4-20 nuts (H) as shown in fi g. 6.5. 6-3
Open the wireless receiver enclosure (A) and unplug the wireless receiver power cord from the wireless receiver.
Remove the wireless receiver and sub panel assembly as shown in fi g. 6.3. Loosely attach the large enclosure
mounting brackets (K) to the wireless receiver enclosure (A) with two 1/4-20 x 1/2 socket head screws (G) and
two 1/4-20 nuts (H) as shown in fi g. 6.4. NOTE: The enclosure mounting bracket can be installed with the inside
notch facing downward if additional side to side adjustment is needed. Position and tighten the four 1/4-20 x 1/2
socket head screws (G) using 4mm allen wrench (L). Press in two plastic plugs (F) into holes shown in fi gure 6.4.
A
WIRELESS
RECEIVER
SUB PANEL
ASSEMBLY
WIRELESS
RECEIVER
POWER CORD