Xoro HSD 8550 - Manual (Page 60)

14 HSD 8550
Engl
ish
Connection
Connecting with a YUV (Y Pb Pr) cable
YUV (Y Pb Pr) is a transmission technology separating colour and brightness information in the
signal. Similar to RGB, the signals are transmitted on a 3 wire cinch [RCA] cable. This way of
transmission is also called “component”. This connection offers best picture quality available with
analogue signal transmission.
Plug a cable into the Y Pb Pr socket on the rear side of your DVD player. You can recognize the
sockets by their colours red, green and blue easily. The other side of the cable must be connected
to the Y Pb Pr input socket of the TV-set (usually labelled „Y Pb Pr“ or „HDTV IN“.
Please change the video output in the Setup settings to “YUV”. In case, that your TV set supports
progressive Scan, you can choose by the settings “Resolution” by the option “Video Settings”.
Please uses a resolution of 576p or 720p and than the player transmit a progressive signal to the
TV set.
As YUV does not transmit sound, you also must add an audio connection. Insert one end of the
supplied audio (Cinch [RCA]) cable into the white/red Cinch [RCA] socket L/R AUDIO OUT at the
back of the DVD player and the other end into the audio input socket (usually white/red) on the TV
set (usually labelled “AUDIO IN” or “AV IN”. Please also refer to your TV set’s user manual). Switch
on the TV set and select the YUV input or the respective channel number. For channel number and
input selection please also refer to your TV operating instructions.
Note:
Make sure you observe the colours of the three sockets when you establish the connection. When
the colours are connected in a wrong way, no picture or a picture with wrong colours will be
displayed.
Connecting with a HDMI Cable
HDMI is a digital transmission technology for both audio and video. Connect the DVD player and
display with a HDMI-HDMI cable. Please note that some TV set can not support RAW audio. In this
case, please set the DVD player audio digital output to PCM.
If your TV set is not equipped with HDMI, but with DVI input, you can use a conversion cable or an
adapter to DVI.
As DVI does not transmit sound, you also must add an audio connection. Insert one end of an audio
(Cinch [RCA]) cable into the white/red Cinch [RCA] socket ML/MR AUDIO OUT at the back of the
DVD player and the other end into the audio input socket (usually white/red) on the TV set (usually
labelled “AUDIO IN” or “AV IN”. Please also refer to your TV set’s user manual)
You can choose in the settings “Resolution” by the option “System Settings” the resolution which
you want or which the TV set supports.
Switch on the TV set and select the HDMI or DVI input. For input selection please also refer to your
TV operating instructions.
Video Output