Zanussi ZBB25430SA - Manual (Page 23)

Problem Possible cause Solution
Water flows into the refrig-
erator. The water outlet is clogged. Clean the water outlet.
Products prevent that water flows
into the water collector. Make sure that products do not
touch the rear plate.
Water flows on the ground. The melting water outlet does not
flow in the evaporative tray above
the compressor. Attach the melting water outlet to the
evaporative tray.
The temperature in the ap-
pliance is too low. The temperature regulator is not set
correctly. Set a higher temperature.
The temperature in the ap-
pliance is too high. The temperature regulator is not set
correctly. Set a lower temperature.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
Remove the screw
from the lamp cover.
Remove the lamp
cover (refer to the il-
lustration).
Replace the used
lamp with a new lamp
of the same power
and specifically de-
signed for household
appliances (the maxi-
mum power is shown
on the lamp cover).
Install the lamp cover.
Tighten the screw to
the lamp cover.
Connect the plug to
the mains socket.
Open the door. Make
sure that the light
comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
23
www.zanussi.com