Peerless-AV LCV-100 - Installation - Manual (Page 2)

ISSUED:11-7-02 SHEET #: 090-9066-8 12-17-13
Visit the Peerless Web Site at www.peerless-av.com For customer service call 1-800-865-2112.
2 of 4
G
DESKTOP
C
C
DESKTOP
H
I
K
Mark hole on desktop for positioning mount.
Drill one 1/2" dia. hole through desktop. Attach
mounting base ( C) to desktop using hex bolt (H),
pressure plate ( K), and hex nut (I). Tighten nut
using proper sized wrench.
Important! Mount is to be installed onto desktops
3/4" to 1-5/8" thick only! For thicker mounting
surfaces, you may have to provide your own
hardware.
There are two methods of installation. Follow step 2-1 for installation using hex bolt and pressure plate
or step 2-2 using four wood screws.
Use four holes on mounting base ( C) to mark holes
on desktop for positioning mount. Drill four 3/16"
dia. holes through desktop. Attach mounting base
( C) to desktop using four wood screws (G).
• Mount must be installed on wood and/or wood composition surfaces of at least 3/4" thick. However, the installer
must ensure that the mounting surface will safely hold the combined weight of the mount and the screen. See other
mounting requirements below.
CAUTION
Remove telescopic pedestal ( A) from
mounting base ( C) by loosening set screws
where shown with 3 mm allen wrench ( B).
SET SCREWS
A
C
2-2 2-1