Peerless-AV ST632-AW - Installation - Manual (Page 8)

8 of 29 ISSUED: 09-20-11 SHEET #: 203- 9047-2 02-08-12
To attach display to tilt assembly (B), lower hook
bracket (A) into pockets of wall mount. Once clips
are engaged, push down to seat clips into pockets.
Tighten M5 x 6 mm screw (L) to lock display to tilt
assemby.
Tighten M5 x 6 mm socket pin screw (L) using 4 mm
security driver (M) to lock display to tilt assemby.
To remove display from mount, loosen M5 screw
(L) and lift display off of mount.
Installing and Removing Flat Panel Display
4
A
B
DISPLAY
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 20 in. • lb (2.26 N.M.) maximum torque.
CAUTION
• Do not lift more weight than you can handle.
Use additional man power or mechanical lifting
equipment to safely handle placement of the display.
• Failure to lock hook bracket (A) with screw (L) can
cause display to come off mount if hit accidentally.
WARNING
Adjust tension knob on right side of mount shown in
fi gure 5.1 to desired tension to balance your display
size and weight.
NOTE: If knob is inaccessible, remove display from
mount, adjust tension knob to desired tension to
balance your display size and weight, and reattach
display to mount as stated in step 4.
Push or pull from top or bottom of display to adjust
tilt as shown in fi gure 5.1. The tilt can be adjusted to
a maximum of 15° forward or 5° backward.
NOTE: To lock the display into the desired tilt
position, tighten tension screw on left side of mount
shown in fi gure 5.2 using phillips screw.
5
Adjusting the Tilt Angle of the Flat Panel Display
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
• Be careful not to pinch fi ngers when pushing display
from the bottom.
CAUTION
fi g. 5.1
fi g. 5.2
TENSION KNOB
TENSION SCREW
L
POCKET
CLIP