beautypg.com

Drain hole locations, Packaging contents, Step 1: install l-shaped front sill – Pace-Edwards JR Series Ford Ranger User Manual

Page 2: Tools required for assembly: before you start, Caution

background image

Read the instructions carefully before you start. These instructions are written for one-person installation. We
have noted where briefl y having an extra person’s assistance can make installation easier. If you have questions
regarding the installation please call our Technical Support Line at (800) 338-3697.

DRAIN HOLE LOCATIONS:

The JackRabbit is designed to carry rainwater from the cover into
the canister and then out through the drains. Most truck models
have standard OE drain holes or plastic/rubber access ports in the
front of the truck bed. Check to make sure your truck has the OE
drain holes so that drilling into the sheet metal is not required. If
drilling is necessary, be sure to check the underside of the truck bed
for the best location. The holes should be located near the side and
as far forward as possible. Use a drill bit suitable for sheet metal
(such as a taper drill or step drill). Drill drain tube clearance holes at
3/4” (19mm). This will need to be done before installing the cover.

FIG. 1

Drain Tube Holes

JACKRABBIT

®

Europe Ranger

Note: There should be no drilling into the truck body needed on most standard or full-size trucks

.

PACKAGING CONTENTS:

In separate Rail
box Rails (left &
right)

Hardware Pack

Clamp Pack

Drain Tubes

Complete Canister Assembly

Top Cover

DO NOT USE A KNIFE TO OPEN THE RAIL BOX. OPEN THE RAIL BOX ALONG
THE LENGTH OF THE BOX AND LIFT RAILS OUT TO AVOID SCRATCHING THE
SURFACE OF THE RAILS ON THE PACKAGE STAPLES.

3/8” wrench or socket
7/16” wrench or socket

5/16” wrench or socket
12 mm wrench or socket

2

STEP 1: INSTALL L-SHAPED FRONT SILL

Inside the Truck Bed, remove the two bolts from each of
the rear window guard tie downs.

Peel the liner off the back of the foam on the back of the
L-shaped Front Sill. Line the holes in the L-shaped front
sill up with the top holes in the tie downs. Re-install the
bolts and tighten completely.

You may use the 3 tek screws to further secure the L-
shaped front sill if necessary.

TOOLS REQUIRED FOR ASSEMBLY:

BEFORE YOU START:

CAUTION!

CAUTION!

Side Cut Pliers
#2 Phillips screwdriver

OPTIONAL

HARDWARE USED:

12 x 1” TEK SCREW x 3

L-Shaped Front Sill

Window Guard Tie Down
L-shaped front sill

Top Bolt in Truck Bed

Tape Measure