Step 4 : secure wires, Step 3 : locate & connect wires (continued) – Pace-Edwards PowerGate LK170 Dodge Ram 1500 (2009-2010) User Manual
Page 2
STEP 4 : SECURE WIRES
Install tailgate access panel. Secure all wires with wire ties provided so that there are no loose, dangling ends.
STEP 3 : LOCATE & CONNECT WIRES (CONTINUED)
Inside the engine compartment locate the positive post next to the fuse panel on the fender well. Open the cap for the
positive post, remove the nut and slip the red wire with the fuse holder on that post. Re-install the nut and close the cap.
Find the ground-wire bolt on the driver side fender well and remove it. Install the black wire to the ground-wire bolt and
make sure you get all of the black ground wires that were there when you started, re-install the bolt.
Return to the cab and make sure the door locks and tailgate lock work. Test the lock by locking and unlocking your
power door locks. If the lock/unlock direction of the PowerGate does not correspond with the direction of your door locks
then switch the purple and gray loom wires where they are attached to the door lock wires and test again.
2400 Commercial Blvd., Centralia WA 98531 • (800) 338-3697 • www.paceedwards.com
Thank you for choosing products by...
LK170-09/08