beautypg.com

Step 4: installing rails, Step 5: installing clamps, Do not tighten over 120-inch pounds – Pace-Edwards BL Ford SuperCrew (2000-2003 Only!) User Manual

Page 4

background image

BEDLOCKER

®

FORD SUPER CREW

4

STEP 4: INSTALLING RAILS

The machined end of the rail attaches to the
canister.

You will need to lift the hanging portion of the
ribbed blanket and thread it in the rail while sliding
the rail into the rail grip mounted to the ends of
the canister (the underside of the blanket ribs
need to nest on the gear
)
.

Make sure both fl anges of rail slide into the rail
grip.

Push the rails forward against the canister.

Complete for both left and right rails.

Remove the support or stand and lower the
canister and rail assembly onto the front sill and
rails of the truck bed.

Slide the entire canister and rail assembly forward
against the cab end of the truck bed.

Close the tailgate and pull the rails only toward it leaving approximately 1/8” gap between the end of the rails and
the tailgate.

Be sure to hold the canister in place to ensure it does not move from the front truck bed sill with the rails while
adjusting the gap of the rails to the tailgate.

Rail Grips

Rail
Flange

Ribbed
Blanket

STEP 5: INSTALLING CLAMPS

HARDWARE USED:

Hold the rail level and against the side
of bed, then install self-drilling Tek
screw into the vertical post at the rear
of box (Figure 5B). Place the rubber
grommet between the bracket and
post tighten screw securely but do not
over compress the grommet.

Place the four clamps (Fig. 5A)
over the rail brackets located on the
underside of the rails.

Locate the upper groove of inner clamp
bracket onto the lip of rail bracket.

Rotate the outer clamp bracket
clockwise to tighten rail downward
against bed rail.

Tighten all bolts securely.

(Adjust pressure against tailgate by
moving rails forward or backward
as needed prior to fi nal tightening of
clamps
.)

Do not tighten over 120-inch pounds!

Rail

Inner Clamp
Bracket

Bolt & Lock
Washer

Outer Clamp
Bracket

Rail Bracket

FIG. 5A

Rail

Rear Rail
Bracket

Rubber
Grommet

Tighten screw securely but do
not over compress grommet.

OUTER & INNER RAIL
CLAMPS x 4

1/4” FLAT WASHER x 4

1/4” LOCK WASHER x 4

RAIL CLAMP BOLT x 4

REAR RAIL BRACKET TEK
SCREW x 2

REAR RAIL BRACKET
RUBBER GROMMET x 2

Vertical
Post at
rear of
bed

FIG. 5B