Pace-Edwards BL Toyota 07-Current Tundra - Manual (Page 4)

STEP 5: INSTALLING CLAMPS & SHIMS
STEP 4: INSTALLING RAILS
The machined end of the rail attaches to the
canister.
You will need to lift the hanging portion of the
ribbed blanket and thread it in the rail while sliding
the rail into the rail grip mounted to the ends of
the canister (the underside of the blanket ribs
need to nest on the gear).
Make sure both fl anges of rail slide into the rail
grip.
Push the rails forward against the canister.
Complete for both left and right rails.
Remove the support or stand and lower the
canister and rail assembly onto the front sill and
rails of the truck bed.
Slide the entire canister and rail assembly forward
against the cab end of the truck bed.
Close the tailgate and pull the rails only toward it leaving approximately 1/8” gap between the end of the rails and
the tailgate.
Be sure to hold the canister in place to ensure it does not move from the front truck bed sill with the rails while
adjusting the gap of the rails to the tailgate.
Rail Grips
Rail
Flange
The Tundra bed is square and the clamps have been designed to fi t without shimming.
Make sure canister is centered between the truck bed rails and completely forward in the
bed.
Slide rail grip components onto rail.
Push forward clamp against the canister and rear clamp about 6 inches to a foot from the
tailgate.
Slide track nuts into the track system and use attachment hardware (Flat washer, Lock
washer & Bolt) to secure clamps in place per FIG 5a. Use 1/8” Allen Wrench to install and
tighten the cone point set screws in the clamps.
Measure the distance between the rails at the canister and tailgate ends. Compare this
distance after clamping it should be the same to allow your cover to operate properly. A
slightly tighter fi t (but NOT Dragging) is better than slightly loose.
If the bed does not have the deck rail track system you will use the pinch clamp in place of
the track nut. (Fig 5b)
BEDLOCKER ® 07 TUNDRA
4
CLAMP x 4
Ribbed
Blanket
HARDWARE USED:
TRACK NUTS x 4 (used
if truck bed has track
system)
PINCH CLAMP x 4 (used if
truck bed DOES NOT have
the deck rail track system)
1/4” FLAT WASHER x 4
1/4” LOCK WASHER x 4
RAIL CLAMP BOLT x 4
CLAMP
TRACK NUT
DECK RAIL
TRACK SYSTEM
HARDWARE
(Flat washer, Lock
washer, & Bolt)
RAIL
CLAMP
HARDWARE
(Flat washer, Lock
washer, & Bolt)
RAIL
PINCH
CLAMP
(used if the
Deck Rail
System
Track is not
installed)
FIG. 5a FIG. 5b
SET
SCREW
CONE SET SCREWS x 4
SET
SCREW