Pace-Edwards JR Series Nissan Frontier SB - Manual (Page 5)

5 INSTALLATION INSTRUCTIONS
You have now completed the installation of your JackRabbit hard tonneau cover. If you have any questions please do
not hesitate to call us at: (800) 338-3697 and ask for our technical service department.
Place the Top Cover on the canister and install
with the two black Top Cover screws into the top
cover mounting blocks. (we recommend that you
use a thread locking adhesive like Loctite® on the
screws)
Retract the cover to the fully open position.
Attach the 4” Velcro strip onto the Velcro strip
already attached to the pull strap.
Pull the pull strap over to the driver’s side rail and
remove the tape from the 4” Velcro strip.
Then apply the Velcro strip onto the underside of
the rail at your desired position.
This will hold the pull strap off of the fl oor and out
of the way when cargo is being stored in the truck
bed.
STEP 9: ATTACHING TOP COVER & VELCRO TO PULL STRAP
HARDWARE USED:
4’ VELCRO STRIP
BLACK TOP COVER
SCREW x 2
STEP 8: INSTALLING DRAIN TUBES
First ensure that the “o” ring is in place on the drain tube end being inserted into the canister (This will prevent
water leakage). Test fi t the drain tube to determine the length you want to trim it. Always caution on the long side.
Trim the end that will be inserted through the truck bed with the wire cutters or a utility knife.
With the cover opened, insert the drain tube fi ttings into the pre-drilled holes on the underside of the canister by
pushing them in place from under the canister. Drain tube should click into place.
Place the other end of the drain tube through the plastic/ rubber access port or through the pre-drilled holes in the
fl oor or the front wall of the truck bed.
DRAIN TUBE FITTING
NOTE: If the OE access ports are located on the front wall of the truck bed you should ensure that the drain-
tubes are inserted and directed down so water fl ows out of the truck.
Washer