Pace-Edwards JackRabbit Series Standard - Manual (Page 2)

Read the instructions carefully before you start. These instructions are written for one-person installation. We
have noted where briefl y having an extra person’s assistance can make installation easier. If you have questions
regarding the installation please call our Technical Support Line at (800) 338-3697.
DRAIN HOLE LOCATIONS:
The JackRabbit is designed to carry rainwater from the cover into
the canister and then out through the drains. Most truck models
have standard OE drain holes or plastic/rubber access ports in the
front of the truck bed. Check to make sure your truck has the OE
drain holes so that drilling into the sheet metal is not required. If
drilling is necessary, be sure to check the underside of the truck bed
for the best location. The holes should be located near the side and
as far forward as possible. Use a drill bit suitable for sheet metal
(such as a taper drill or step drill). Drill drain tube clearance holes at
3/4” (19mm). This will need to be done before installing the cover.
FIG. 1
Drain Tube Holes
JACKRABBIT ® SERIES
Note: There should be no drilling into the truck body needed on most standard or full-size trucks .
PACKAGING CONTENTS:
In separate Rail
box Rails (left &
right)
Hardware Pack
Clamp Pack
Drain Tubes
Complete Canister Assembly
Top Cover
DO NOT USE A KNIFE TO OPEN THE RAIL BOX. OPEN THE RAIL BOX ALONG
THE LENGTH OF THE BOX AND LIFT RAILS OUT TO AVOID SCRATCHING THE
SURFACE OF THE RAILS ON THE PACKAGE STAPLES.
3/8” wrench or socket
7/16” wrench or socket #2 Phillips screwdriver
Tape measure
2
STEP 1: REMOVE PACKAGING PLYWOOD & HARDWARE
Remove the canister from the box. Using the 3/8” wrench or socket remove the 2 bolts holding the plywood on the
ends of the canister.
DISCARD PLYWOOD PACKAGING AND BOLTS!
TOOLS REQUIRED FOR ASSEMBLY:
BEFORE YOU START:
CAUTION! CAUTION!
Side Cut Pliers
JackRabbit 800-338-3697
JACKRABBIT Made in the USA by Pace Edwards Co. Model # Serial #
JACKRABBITTM TONNEAU COVER by:
(800) 338-3697