Pace-Edwards JR Series Toyota Tundra StepSide - Manual (Page 4)

STEP 4: INSTALL CHANNEL
Peel the foam backing and attach it to the bottom of the channel.
Bolt the Canister Channel assembly to the rails using the Black #10-32 x 3/4” Flat head
Screw provided. (Figure 4A & 4B)
Black #10-32 x 3/4”
Flat head Screw
Rail
Canister
Channel
#10 Washer
#10-32 Nut
Closed Cell
Foam
Truck
Bed Sill
Canister Channel
Completed Assembly
4
HARDWARE USED:
CLOSE CELL FOAM x 1
#10-32 x 3/4” FLAT HEAD
SCREW x 2
#10 FLAT WASHER x 2
#10-32 NUT x 2
Canister
Slide canister and rail assembly against the front cab sill of the truck bed. Remove the support(s) under the
canister so that the canister and rails rest fi rmly on the sides of the truck bed.
STEP 5: REPOSITIONING CANISTER
Open the rail box along the length of the box; lift rails
out to avoid scratching the rail surface on the package
staples.
The side rails are marked “left” and “right” (left is the
driver’s side of the truck).
With the tailgate closed, place the side rails in position on
the truck bed.
Install the tailgate end of the pull strap to the underside of
the drivers side rail using the #8-32 x 3/4 machine screw
located at the tailgate end on the underside of the rail.
STEP 6: INSTALL TAILGATE END OF PULL STRAP
HARDWARE USED:
PULL STRAP x 1
(TAILGATE END)
JACKRABBIT SERIES TUNDRA STEPSIDE