Pace-Edwards JR Series Honda Ridgeline - Manual (Page 6)

JACKRABBIT® SERIES RIDGELINE 6
You have now completed the installation of your JackRabbit hard tonneau cover. If you have any questions please do
not hesitate to call us at: (800) 338-3697 and ask for our technical service department.
Place the Top Cover on the canister and install
with the two black Top Cover screws into the top
cover mounting blocks. (we recommend that you
use a thread locking adhesive like Loctite® on the
screws)
Retract the cover to the fully open position.
Attach the 4” Velcro strip onto the Velcro strip
already attached to the pull strap.
Pull the pull strap over to the driver’s side rail and
remove the tape from the 4” Velcro strip.
Then apply the Velcro strip onto the underside of
the rail at your desired position. (Figure 8a)
This will hold the pull strap off of the fl oor and out
of the way when cargo is being stored in the truck
bed.
STEP 8: ATTACHING TOP COVER & VELCRO TO PULL STRAP
HARDWARE USED:
4’ VELCRO STRIP
BLACK TOP COVER
SCREW x 2
FIG.8a