GlowShift Fuel Pressure Sensor Relocation Kit User Manual
Fuel pressure sensor relocation kit

For Full Warranty Information Visit GlowShift.com
Fuel Pressure Sensor Relocation Kit
1. Thread the female end of the -4 AN fitting onto the male end of the 1/8
th
NPT sensor and tighten.
2. Thread the male end of the -4 AN fitting into the 1/8th NPT port where you are going to measure your desired pressure.
3. Thread the female end of the remote line onto the male end of the -4AN fitting that is attached to your pressure port and
tighten.
4. Route the line to your remote mounting location, a couple good positions are the firewall or fender well. Be sure to keep the
remote line away from any moving parts or direct heat source, and secure with wire ties if necessary.
5. Attach the female end of the remote line to the male end of the -4AN fitting with the sensor and tighten.
6. Use the supplied cushion clamp to secure the remote line to an existing bolt on your firewall or fender well. If you have
to drill, be sure to check for wires or lines and make sure you are not drilling through the body of the vehicle before.
7. Finish installing your fuel pressure sensor by following the instructions that are included with your gauge.
- 7 Color Series 30,000 PSI Fuel Rail Pressure Gauge (4 pages)
- Tinted Series 30inHG ~ 30PSI – Boost_Vacuum Gauge (3 pages)
- 7 Color Series Vacuum Gauge (3 pages)
- 3in1 Diesel Combination Gauge, Temperature (3 pages)
- Elite 10 Color Oil Pressure Gauge (3 pages)
- 03-09 Dodge Ram Triple Pillar Gauge Pod (1 page)
- -4AN Fuel Rail Adapter (1 page)
- Elite 10 Color Water Temperature Gauge (3 pages)
- MaxTow Series Volt Gauge (3 pages)
- MaxTow Series Oil Pressure Gauge (3 pages)
- Elite 10 Color Series Tachometer Gauge (3 pages)
- Water Temperature Sensor Adapter (1 page)
- Elite 10 Color Series Wideband Air_Fuel Ratio Gauge (3 pages)
- Tinted Series Oil Temperature Gauge (3 pages)
- 7 Color Series 100 PSI Fuel Pressure Gauge (3 pages)
- 7 Color Series 3,34 Inch In-Dash Speedometer (3 pages)
- 7 Color Series Volt Gauge (3 pages)
- 7 Color Series 35 PSI, 60 PSI, 100 PSI Boost Gauge (3 pages)
- 7 Color Series Wideband Air_Fuel Ratio Gauge with Data Logging Output (4 pages)
- Elite 10 Color Oil Temperature Gauge (3 pages)
- 7 Color Series BAR Boost_Vacuum Gauge (3 pages)
- Single Gauge Pillar Pod (1 page)
- Digital Series BAR Boost_Vacuum Gauge (3 pages)
- Elite 10 Color BAR Oil Pressure Gauge (3 pages)
- Ford Super Duty 7.3 Powerstroke Fuel Pressure Sensor Adapter (1 page)
- Ford Super Duty 6.0 Powerstroke Fuel Pressure Sensor Adapter (1 page)
- Full Size Gauge Pillar Pod (1 page)
- Tinted Series Transmission Temperature Gauge (3 pages)
- 02-07 WRX Clock Replacement Triple Gauge (2 pages)
- 98-02 Dodge Ram Triple Pillar Gauge Pod w_ Speaker (1 page)
- Tinted Series Fuel Pressure Gauge (3 pages)
- 3 Gauge Wiring Kit (1 page)
- Elite 10 Color Series Boost_Vacuum Gauge (3 pages)
- Elite 10 Color Pyrometer EGT Gauge (3 pages)
- Tinted Series 0~200PSI Air Pressure Gauge (3 pages)
- Digital Series Volt Gauge (3 pages)
- 3in1 Boost_Vacuum Combination Gauge (2 pages)
- Elite 10 Color Series 3,34 Inch In-Dash Speedometer Gauge (3 pages)
- 7 Color Series 220 PSI Dual Digital Air Pressure Gauge (3 pages)
- 7 Color Series BAR Oil Pressure Gauge (3 pages)
- Digital Series Transmission Temperature Gauge (3 pages)
- Elite 10 Color Series BAR Boost_Vacuum Gauge (3 pages)
- Digital Series Oil Temperature Gauge (3 pages)
- Digital Series Pyrometer EGT Gauge (3 pages)
- Adjustable Shift Light (2 pages)