GlowShift 02-07 WRX Clock Replacement Triple Gauge - Manual

02-07 WRX Clock Replacement Triple Gauge Pod Installation Instructions
1. Prior to installing this gauge pod, disconnect the negative side of the battery.
2. To install this pod you first need to remove the factory clock from your dashboard.
3. To remove the clock, simply insert a flathead screwdriver into the seam on the back of the clock and twist until it pops out.
4. Once the clock housing has been popped out, disconnect the wiring harness and completely remove the clock from your
dashboard.
5. Install the left and right L style mounting brackets to precut center hole where you removed the clock. Be sure to use the
included washers for a proper fit.
Note: When installing the mounting brackets, be sure that the washers are placed on the underside of the underside of the
side along with the nut.
6. Place the gauge pod over the empty space where you removed your clock. Line the pod up to the mounting brackets and
use a scoring tool to mark where the brackets meet the pod.
7. Using a 1/8 th inch drill bit; drill a hole on either side of the pod for the included screws where you marked with the scoring
tool.
8. Install your gauges into the pod by following the instructions that are included with them.
9. Once your gauges are properly installed, finish the installation of the gauge pod by placing over the brackets and aligning
the drill holes to the bracket holes. Finish mounting the pod by screwing the included black screws into the left and right
mounting brackets.
10. Now that your gauge pod and gauges are installed reconnect the negative side of the battery.