GlowShift MaxTow Series Water Temperature Gauge - Manual (Page 2)

Selectable Brightness Levels:
The Double Vision Gauge Series features 3 selectable brightness settings for both day and night time lighting modes. Below are the instructions on
how to program each lighting mode.
Day Mode

Press and hold the button located on the gauge face until a d1 appears in the digital display.

Press the button again to cycle through the 3 dimming modes.

Once you have selected your desired setting release the button and the gauge will save your selection.
Night Mode

This mode is only available if the orange dimmer wire is connected, and your headlights are powered.

Press and hold the button located on the gauge face until a n1 appears in the digital display.

Press the button again to cycle through the 3 dimming modes.

Once you have selected your desired setting release the button and the gauge will save your selection.
Additional Installation Information & Material Requirements

MaxTow Gauges Approved Conductor Wires: Successfully installing MaxTow Gauges may require lengths of wire (sizes and quantity
depend on vehicle, gauge type, gauge location and / or sensor location). For correct and proper MaxTow Gauge installation and operation, the
use of 18 Gauge (wire diameter) automotive grade conductor wire with sheathing is recommended for one or more gauges per vehicle. When
installing and routing wires from the engine compartment, to inside the vehicle cabin, always employ the use of a rubber grommet. This will
prevent and deter the stripping of power supply and / or sensor wires that is necessary to deliver vital statistics about your engine to your
MaxTow engine monitoring instruments. Never use wire nuts to fasten or bound vehicle / gauge or sensor wiring. Always use securing crimp
connectors or solder individual wire junctions together for optimum gauge installation and operation.

MaxTow Gauges Approved Installation Accessories: MaxTow Gauges may require the installer or user to provide additional products,
accessories or adapters for the correct installation and operation of a gauge or sensor, as per the MaxTow Installation Instructions. When
installing and routing hoses to or from the engine compartment, to inside the vehicle cabin, always employ the use of a rubber grommet. This
will prevent and deter the stretching or pinching of hoses that is necessary to deliver vital statistics about your engine to your MaxTow engine
monitoring instruments.

MaxTow Gauges Installation Instructions: Installation documents are solely to provide a guide for individuals that are mechanically and
electronically able to install products. If you are unsure about the correct procedure of installation for a product or device, you should consult a
professional mechanic or an Authorized MaxTow Installer. Any malfunctions or damages that result from improper installation will not be
covered under MaxTow’s one year limited warranty.