GlowShift Digital Series Fuel Pressure Gauge User Manual
Page 2
Additional Installation Information & Material Requirements
GlowShift Gauges Approved Conductor Wires: Successfully installing GlowShift Gauges may require lengths of wire (sizes
and quantity depend on vehicle, gauge type, gauge location and / or sensor location). For correct and proper GlowShift Gauge
installation and operation, the use of 18 Gauge (wire diameter) automotive grade conductor wire with sheathing is recommended
for one or more gauges per vehicle. When installing and routing wires from the engine compartment, to inside the vehicle cabin,
always employ the use of a rubber grommet. This will prevent and deter the stripping of power supply and / or sensor wires that is
necessary to deliver vital statistics about your engine to your GlowShift engine monitoring instruments. Never use wire nuts to
fasten or bound vehicle / gauge or sensor wiring. Always use securing crimp connectors or solder individual wire junctions
together for optimum gauge installation and operation.
GlowShift Gauges Approved Installation Accessories: GlowShift Gauges may require the installer or user to provide additional
products, accessories or adapters for the correct installation and operation of a gauge or sensor, as per the GlowShift Installation
Instructions. When installing and routing hoses to or from the engine compartment, to inside the vehicle cabin, always employ the
use of a rubber grommet. This will prevent and deter the stretching or pinching of hoses that is necessary to deliver vital statistics
about your engine to your GlowShift engine monitoring instruments.
GlowShift Gauges Installation Instructions: Installation documents are solely to provide a guide for individuals that are
mechanically and electronically able to install products. If you are unsure about the correct procedure of installation for a product
or device, you should consult a licensed professional.
ONE YEAR NON-TRANSFERRABLE LIMITED WARRANTY AND DISCLAIMER
GlowShift Gauges, LLC ("GlowShift") warrants to the original retail consumer purchaser, and not any other purchaser or subsequent
owner, that this Product will be free from defects in material or workmanship for a period of one (1) year from the purchase date.
For a period of one (1) year from the date of purchase, at no charge to the Purchaser, GlowShift will repair or replace this Product if it
is determined by GlowShift to be defective. After the warranty period, the Purchaser must pay all charges for parts and labor.
Coverage under this warranty is only valid within the United States, including its territories, as well as in certain other countries.
Purchasers should check our website,
to determine the warranty coverage in the countries in which they are
located.
GlowShift does not warrant the installation of the Product, which is the sole responsibility of the Purchaser. Installation should be
done by licensed professionals. Improper installation may cause damage to the Product and any vehicle in which it is installed, and
may cause burns and electrical injury to individuals. GlowShift’s warranty does not cover any expenses incurred in removing
Products that are defective or re-installing replacement Products in their place.
During the warranty period, to have the Product repaired or replaced, the Purchaser must return the Product, freight prepaid by the
Purchaser, to GlowShift (but for customers in the contiguous United States, GlowShift will pay the shipping charges if any Product
fails during the first thirty (30) days after purchase). The Product must be returned in its original carton or in a similar package
affording an equal degree of protection. GlowShift will return the repaired or replaced Product, freight prepaid, to the Purchaser.
GlowShift does not provide Purchasers with temporary replacement units during the warranty period or at any other time.
This limited warranty is non-transferrable and will automatically terminate if the original retail consumer purchaser resells the Product
or transfers the vehicle in which the Product is installed. An “original retail consumer purchaser” is a person who originally purchases
the Product, or a gift recipient of a new Product that is in its original packaging and unopened.
This limited warranty is subject to all of the following terms and conditions:
TERMS AND CONDITIONS
1. NOTIFICATION OF CLAIMS; WARRANTY SERVICE: If Purchaser believes that a Product is defective in material or
workmanship, written notice with an explanation of the claim shall be given promptly by Purchaser to GlowShift. All warranty claims
must be made within the warranty period, and any Products returned to GlowShift must be shipped in accordance with GlowShift’s
procedures (including use of RMA numbers supplied by GlowShift after notification). The repair or replacement of any Product or
part thereof shall not extend the original warranty period. The specific warranty on the repaired part only (not including gauge
sensors) shall be in effect for a period of ninety (90) days following the repair or replacement of that part, or the remaining period of
the Product warranty, whichever is greater. GlowShift does not provide a warranty on replacement gauge sensors.