American Car Craft Chrysler_300_Dodge Charger_Magnum_ Srt 8 Fuel Rail Covers Polished_Perforated "HEMI 2008-2011" - Manual (Page 2)

These new covers are made of the best quality polished 304 stainless steel, to a beautiful mirror
finish. They have been carefully designed to fit over the factory plastic covers and mount
together via Velcro attachment tape.
1. Remove the factory plastic fuel rail covers by pulling up on them to detach from push-on
fasteners.
2. You will need to perform a mini “wire tuck” for the coil pack wires to be relocated
properly. Simply mark its location and disconnect each coil wire, relocate these wires to
be in the valley between the aluminum intake manifold and the valve cover. Make sure
the wires are not too tight, binding or near any moving parts. This will allow you to
reposition the wires out of the way. (In case you plan to install our Engine Wire Harness
Cover and give you the room to easily install the harness cover.) Once the wires have
been reposition, re-attach each coil wire to its original coil.
3. Thoroughly clean the face of the factory covers with alcohol to remove any and all road
grime and dirt. Then swipe the front 3 extruded areas above the coil packs with the
adhesive promoter provided and lastly to the very front side of the plastic cover. This
promoter is NOT a cleaner but an adhesive accelerator and will insure a nice permanent,
long term bond and MUST be used.
4. You have been provided with six Velcro attachment cookies. Peel the release liner from
both sides of each cookie and place them to the 3 areas above the coil packs that you
just promoted. The front side does NOT receive a Velcro cookie.
5. Swipe the underside of the new covers with the adhesive promoter and then carefully
place them over the factory covers. Press them down firmly to set the Velcro cookies.
Also at this time you might want to firmly press the Velcro cookies on the under side of
the covers to ensure a nice bond, and then simply reinstall.
6. At this time you may remove all the protective liners from the covers. NOTE: In some
production models there may be a large wire harness routed in front of the factory fuel
rail cover. Should this be the case, simply reroute the harness to the side, to create
adequate clearance for the new front plate. This may require you to detach the harness
hold down from the valve cover bolts in order to allow you to force the harness cover to
the side.
7. The last part of this install will be to set the decorative chrome cap atop the factory oil
fill cap by cleaning the cap with alcohol to remove dirt then swipe the cap with the
remaining adhesive promoter., remove the Velcro cookie halve from the under side of
the cap and firmly press it to the factory cap then simply set the new cap cover in place.
If any questions occur during installation, please contact American Car Craft at
727-861-1500.
Thank you and enjoy your new purchase!