American Car Craft Corvette Stingray Fuel Rail Lighting Kit 2Pc 2014+ C7 User Manual
American car craft instructions

AMERICAN CAR CRAFT INSTRUCTIONS
C7 CORVETTE STINGRAY FUEL RAIL LIGHTING KIT 2Pc
PART #053002
PARTS INCLUDED:
2- Brushed led Rails
1-Fuse Holder with 7.5 Fuse
2-Adhisive Promoter Tubes
1. The first step will be to remove the black plastic cover from the car. This part is easily removed by
simply pulling the top of the part away from the motor and it will unsnap.
2. The next thing that needs to be done in any peel and stick application is surface preparation. It is
important that you examine the surface to determine if any kind of special treatments have ever been
used. Such as wax/silicone treatments and/or polymer surface preps. Take a strip of masking tape and
press it very firmly to make it adhere to the surface. Then peel it off to see how difficult it is to remove.
If your masking tape is removed extremely easy and/or does not stick at all then you will need to
perform a special surface preparation. In most cases like this you will need to make a solution of a
straight detergent (Johnson’s Baby Shampoo or Palmolive Dish Soap) and water. Mix a 32oz bottle with
about five table spoons of soap detergent. Once you have the solution made wash the surface
scrubbing quite vigorously to remove any surface contaminates.
3. When this is done you can proceed to the regular preparation. This is done by scrubbing the surface
with alcohol and wiping it dry. At this point you will need to test the surface again to see if you have
achieved a tack. Apply a new strip of masking tape to the surface. If it adheres you have done a good