American Car Craft Prowler 3rd Brake Light Trim with Kat Logo Polished 1997-2002 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
Prowler High Polished Stainless Steel 3
rd
Brake Light Bezel
PART #822010
PARTS INCLUDED:
1-3
rd
Brake Light Bezel
1-Adhesive Promoter
PROTECTIVE LINER INFORMATION: Your new accessories will come to you with a protective surface liner.
Leave this liner in place until the installation is complete to prevent finger prints and/or possible scratches
during installation.
1. Wash your 3rd Brake light with soap and water. Rinse thoroughly and dry.
2. Take your Bezel out of the wrapper. Do not remove the back red tape covering.
3. Take your Bezel trim and put it up to your 3rd Brake light. Position it as you want to permanently mount
it. You might want to slightly bend the ends in to match the slight bend in your cars lens assembly. You
can do this by trial and error. Once you are comfortable with exactly how it will fit, move to the next step.
4. Take your promoter pen and wipe the perimeter of your 3rd brake light where the trim bezel is going to
attach.
5. You may now take the red backing off the back side of your trim piece. Very carefully position the Trim
Bezel in place without touching it against the 3rd Brake light. Once you are certain that is where you want
it, lightly set it on the 3rd brake light while still holding it. Make any final tiny adjustments. Once this is
done, press on the bezel to secure it against the 3rd brake light. With your fingers - press all the way
around the bezel to ensure it is sticking to the 3rd brake light on all sides.