beautypg.com

American Car Craft HHR Rear View Mirror Trim Brushed "SS Auto Dim 09-up SS Models" User Manual

American car craftinstructions

background image

AMERICAN CAR CRAFTINSTRUCTIONS

HHR Rear View Mirror Trim “SS” (fits Auto-Dim mirror)

Part #421002

INCLUDES:
1-Rear View Mirror Trim

GENERAL PART INSTALLATION INSTRUCTIONS

Introduction: In the next few paragraphs we will explain to you what you will need to know and do for a
successful application of ACC Stainless Steel Accessories. It is important to understand that almost all
stainless steel peel and stick accessories need to be pre shaped by hand in order to achieve a nice long
term installation. We realize that all parts are different from each other but as far as the installations of
these parts they all will need to follow the same set of general instructions.

Liner info: Your new accessories will come to you with a protective surface liner. Leave this liner in place
until the installation is complete to prevent finger prints and or possible scratches during installation.
This liner is required to remain on the part until you are instructed to remove it.

1. The first thing that needs to be done in any peel and stick application is surface preparation. It

is important that you examine the surface to determine if any kind of special treatments have ever been
used. Such as wax/silicone treatments and/or polymer surface preps. Take a strip of masking tape and
press it very firmly to make it adhere to the surface. Then peel it off to see how difficult it is to remove.
If your masking tape is removed extremely easy and/or does not stick at all then you will need to