American Car Craft Corvette Radiator Cover Polished Component 2Pc 2005-2007 C6 + 2006-2013 Z06 User Manual
Page 2
1. Thoroughly clean the top of the factory black plastic radiator cover with
household rubbing alcohol to remove any and all grime and dirt. Then swipe the
top back edge of the factory cover closest to the motor with the adhesive promoter
provided.
2. You have been provided with two lengths of Velcro attachment tape. Place the
two lengths directly to the edge of the factory cover you just prepared. Press
firmly to set. Expose the tapes adhesive edge so that the top section of the tape
will attach to the new cover once it is set in position.
3. You will notice a large rubber grommet securing the air tube to the factory
radiator cover. Slide the stainless covers notch directly under the air tubes ear so
that it will rest between the grommet and the air tube. Slide it completely in and
set it down so that it will come into contact with the attachment tape installed
earlier and press firmly to set. Lift the cover off the mounted attachment tape and
remove the cover. Firmly press the attachment tape securely to the underside of
the new cover. This will create a nice permanent attachment.
4. Reinstall the cover and adjust its position to achieve a nice straight final position.
Repeat the procedure for the opposite side. Remove the protective liner.
Note: Care must be taken when cleaning your cover. It is a good idea to lightly
dust your cover with a clean soft cloth first in order to prevent any particles from
scratching it. Then wipe (using a new clean soft cloth) with a good quality streak
free glass cleaner. SEE ENCLOSED CARE SHEET!
If any questions occur during installation, please contact American Car Craft
at 727 861-1500.
Thank you and enjoy your new cover!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520