American Car Craft Corvette Taillight Covers Billet Style 4Pc Polished 2005-2013 C6 all User Manual

Page 2

1. Clean each of the taillight openings first with rubbing alcohol to remove any dirt

and wax. Then swipe the painted area closest to the lens with one of the adhesive
promoter packs provided.

2. You have been supplied with four lengths of molding. Starting at the left or right

side of the lens tab at the top of each light place this molding directly to the
painted surface, as you pull the release liner from the back of the molding,
working your way around to the opposite side pressing firmly to set. Trim away
any excess molding. PLEASE NOTE: Make sure that the molding attaches to the
painted surface and that it rest against the taillight lens. This strip of molding
creates a bondable surface for the new covers to attach to.

3. Now that all four taillights have been fitted with the attachable molding, swipe all

four molding strips with the second pack of adhesive promoter provided.
Carefully (DO NOT SCRATCH YOUR PAINT!! you may elect to put some
masking tape on your painted surface area) set each taillight cover in place and
check the overall shape. Although the new covers come to you preformed it will
be necessary to hand form each cover so that it matches the placement of the
molding at both sides ONLY without forcing it. It should lay flat to the left and
right sides of your molding attachment strip only NOT TO THE TOP OR
BOTTOM. This can easily be done by gently shaping each cover with both hands
horizontally until the desired shape is accomplished.

4. Once you are satisfied with the fit of each lens simply peel the red liner from the

back of the cover and carefully place each cover into position making sure that
your lines are all equally placed horizontally (SEE PICTURE) pressing firmly at
the sides ONLY. Doing this will set your new covers to the molding strip installed
earlier. NOTE: Although the back of your covers are fully taped they are designed
to mount to the left and right side of the molding strip ONLY! DO NOT
ATTEMPT TO PUSH IN THE CENTERS or the top and bottom of the lens as
this will distort the final installation!

5. REPLACEMENT KIT INCLUDED: We have provided you with a replacement

kit should you ever need to change one of your light bulbs use this kit to reinstall
your lens cover!

If any questions occur during installation please contact American Car Craft at
727 861-1500. Thank you and enjoy your purchase!

AMERICAN CAR CRAFT

18924 SAKERA RD HUDSON FL 34667

Phone: 727 861-1500 Fax: 727 861-1520