American Car Craft HHR Fog Light Kit Polished 2006-2012 - Manual (Page 2)

temporarily remove the aggressive tack of the attachment tape and allow you to place the
bezels in position). Allow the alcohol to evaporate after a few minutes, once the alcohol
has evaporated simply apply pressure to the inserts to set in place.
4. Now that the main parts of the inserts have been installed prepare the outer rim of the
fog light opening by scrubbing it with alcohol then swiping it with the adhesive promoter
tube. You have been supplied with two lengths of chrome trim. Use this trim to cap the
gap between the new inserts and the fog light opening edge. Begin by snipping one end
of the trim so that it will match the start point of the opening. Peel the red release liner
from the back of the trim and set it onto the painted surface in such a way as to cap the
metal. Work you way around the opposite side then snip the end to match the angle of the
opening. Press firmly along the entire length to set. Do not get wet for 24 hrs.
If any questions occur during installation please contact American Car Craft @
727-861-1500.
Thank you and enjoy your purchase!
Note: EXTRA CARE must be taken when cleaning your stainless kit. It is a good
idea to lightly dust your kit with a clean soft cloth first in order to prevent any
particles from scratching it. Then wipe (using a new clean soft cloth) with a good
quality streak free glass cleaner.