American Car Craft Corvette Vent Spears w_Perforated Vents 8Pc Polished 2005-2013 C6 only User Manual
American Car Craft For the car

AMERICAN CAR CRAFT INSTRUCTIONS
C6 STAINLESS SIDE SPEARS W/ PERFORATED SIDE VENT GRILLES
PART#042047
patent pending
BE SURE TO INSTALL YOUR SIDE VENTS (PART # 042052) BEFORE
BEGINNING THIS INSTALLATION! UNLESS YOU ORDERED YOUR SPEARS
ONLY KIT WITHOUT SIDE VENTS!
PARTS INCLUDED:
6-Stainless Spears
2-Adhesive Promoter Packs
2-OPTIONAL Lengths of Chrome Trim
Paper Template
1. The first step to a successful installation is to prepare the surface first with
soap and water to remove any road grime and dirt. Then scrub the area to be
mounted with household rubbing alcohol. After the entire are is thoroughly
cleaned swipe the area with one of the adhesive promoter packs provided.
2. You have been provided with a paper template for the suggested position of
each spear. Cut the template along the lines indicated. Place the template
along the fenders edge so that it lines up with the very bottom of the vent
hole. You will see that the three cutouts created will evenly and correctly
position each of the spears. The spears are marked starting from top to
bottom 1P, 2P and 3P for passenger side and 1D, 2D and 3D for the driver’s
side. Before you begin permanent installation set each spear into place to get
acquainted with its position. Each spear tip is designed to fit into the vent
hole and to just touch the vent grille. NOTE: THEY ARE NOT DESIGNED
TO HAVE FULL CONTACT WITH THE SIDE VENTS as this will create
an unsightly gap between the fender and the spear.
3. Once you have a good idea of the spears position simply peel and stick all
three spears into place. Press firmly to set a nice bond. Do not get wet for 24
hours.