American Car Craft Corvette Wiper Cowl Cover Polished 2Pc 2008-2013 C6+GS User Manual
Page 2
2. Before you permanently attach any thing place the two long strips of stainless into
position to get acquainted with the fit and to see for yourself just how you will go
about setting each of them in place. The two pieces should butt tight to each other
with no gap. Once you are satisfied with the fit remove the red release liner from
the back of the parts and then carefully set them back into position and press
firmly along its length to set the parts to the factory plastic. Once this is done
remove the protective liner.
3. You have been supplied with an adhesive promoter snaps stick. Squeeze this
small tube until the vile inside breaks releasing the fluid onto the fiber end and
then apply a single bead along the front edge of the two pieces closest to the
engine. You have been provided with a long length of chrome trim. Cut one end
of the trim to match the angle at either end of the stainless inserts and then peel a
small length of the red release liner from the back of the trim and set the end you
just cut. Pull the red liner as you set the trim along the entire length of the
stainless until you reach the corner. Trim the end of the trim to match the shape of
the end point. Reinstall the factory rubber hood gasket.
If any questions or problems occur during installation, please contact American Car
Craft at 727-861-1500.
Thank You and Enjoy Your Purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520