American Car Craft Mustang Fuel Rail Covers 5.0 GT 2Pc Perforated w_Cap - Illuminated 2011-2012 User Manual
Page 2
Liner info: Your new accessories will come to you with a protective surface liner. Leave this
liner in place until the installation is complete to prevent finger prints and or possible scratches
during installation. This liner is required to remain on the part until you are instructed to
remove it.
1. Thoroughly scrub clean the entire surface of the factory fuel rail/coil pack covers to
remove any and all road grime and dirt. Then swipe the areas with the adhesive
promoter provided. This chemical not a cleaner but an adhesive accelerator and must
be used as such in order to expect a good long lasting bond.
2. Before you permanently attach the new stainless covers take a moment to set each
cover in place to get acquainted with their intended position as well as the overall
fitment and contour. Although the new covers come to you preformed it may be
necessary to further tweak their shape by hand in order to achieve the most contact for
a good bond. Once you have everything ready simply peel the red release liner from the
back of each cover and then firmly press them to the stock cover making sure that the
attachment tape has made a good and complete contact. Remove the protective liners.
3. You kit has come to you containing 8 chrome decorative half shell top hat covers and 4
tall top hat covers, each containing butyl putty for mounting. You have also received 4
small zip ties. Once you have finished installing the stainless covers and then installed
the covers onto your engine simply press the 8 half shell covers over each of the 8 coil
pack connectors. This will give these connectors a nice finished look.
4. The 4 remaining covers are to be applied to the 4 electrical sensors just in front of each
fuel rail cover. Since the wires for these sensors are sort of randomly leading up to the
censors. Use the small zip ties to strap the wires at the sensors base around to the back
of the sensor and then trim the zip tie. This will create a nice neat arrangement for the
new chrome caps to set atop the sensors giving a nice custom and complete
appearance. Simply press them onto each censor with the notch in the covers over the
wires you just strapped to the censor.
If any questions occur during installation please call American Car Craft at 727-861-1500.
Thank you for your purchase!
AMERICAN CAR CRAFT
18924 SAKERA ROAD-HUDSON FLORIDA 34667
Phone # 727-861-1500 Fax # 727-861-1520