American Car Craft Corvette Side Vent Grilles 2Pc Laser Mesh Polished 1997-2004 C5 & Z06 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
C5 2-pc LASER MESH STAINLESS VENT GRILLES
PART #032021
PARTS INCLUDED:
2-Stainless Vent Grille w/attachment tape
2-Adhesive Promoter Packs
2- 23”Lengths 1/8” Chrome Molding
1. Jack up the front of the car and secure with a pair of jack stands to ensure safety.
2. Turn the front tire sharply to create adequate working clearance. Remove the
retainers that secure the plastic inner fender well to the painted outer fender.
Doing this creates access to the inner side of the fender vent hole. Once you have
created this access you will need to remove two additional screws that are
securing the vent deflector and remove the deflector. This will create full access
to the vent hole.
3. VERY IMPORTANT: Using a cloth with soap and water wipe the inner side of
the vent on both sides of the hole to remove road grime and dirt. Once this area is
clean scrub both sides of the vent hole with household isopropyl alcohol until
thoroughly clean.
4. You have been provided with two packets of adhesive promoter. Use one of them
and swipe the inner and outer sections of the inside of the vent hole.