American Car Craft Camaro Upper Hood Plate Polished 2010-2013 User Manual
Page 2
2. Thoroughly scrub clean the areas to be mounted with alcohol to remove dirt. Then swipe the area
with the adhesive promoter packet provided. This packet contains not a cleaner but an adhesive
accelerator that will insure the stainless panels stay stuck long term and must be used.
The process for installing both the upper hood plate as well as the lower plate is as follows. The panels
come to you flat. It will be very important to pre shape the panels so that they contour to the hood
perfectly without forcing any part of it to lay down to the paint. You can do this with your hands by
gently rolling and or twisting the metal until it conforms.
3. Once you have achieved a nice contour fit peel a small length of the red release liner from the back of
the panel at each of the attachment tape points to create a sort of pull tab. Create an exact center pull
tab by slicing the red tap at the center of the panels so that you will be able to pull the tabs from the
center out to the ends. With the tabs all set up, set the panel onto the hood and then center it perfectly.
Holding this position pull the center tabs first and work your way out to the sides pulling the other tabs
as you go then press firmly to set. Remove the protective liner and then reinstall the hood.
If any questions occur during installation please contact American Car Craft @ 727 861-
1500.
AMERICAN CAR CRAFT
18924 SAKERA ROAD-HUDSON FLORIDA 34667
Phone # 727-861-1500 Fax # 727-861-1520