American Car Craft Corvette Door Jamb Kit for Lambo Style Doors 2005-2013 C6 User Manual
Page 3
4. Now that you have got the shape of the lower section just right you can begin to
permanently install the section. Remove the red release liner from the both ends
of the section. Pull a small length of the two outer release liners just enough to
overlap the outer edge. These will act as pull tabs. Set the upper end of the part to
the door jam just below the door catch and place the rest of the section in place.
Be sure that it tucks UNDER the door gasket correctly and then hold this position.
Pull the two tabs of release liner out one at a time starting with the one closest to
the door gasket. Pull the liner slowly as you set the part to the door keeping the
part in position. After you have released the back liner then pull the one closest to
you and then firmly set the entire length of the part in place. Again if you consider
that metal will not bend by itself then you can be confident that this section you
have just shaped and installed will NEVER detach itself from a good bond.
5. The section marked #3 is the door catch plate and will cap the two ends of the #1
and #2 sections. Before you permanently set this part; place it in position to get
yourself familiarized with just how you will manipulate it over the catch bar.
Because the catch bar can be in many different places the hole in the catch plate is
large and universal. In order to manipulate the catch plate over the catch bar you
will need to lower the hole and manipulate the plate over the catch bar with the
back edge tilted towards the door skin. Once you have got the plate over the catch
bar bring the plate up into position. Once you have the idea you can remove the
red release liner from the back of the part and then repeat the procedure and
firmly press it to the door jam. Remove the protective liners from the three parts
to finish the installation for that side and repeat the entire process for the opposite
side.
If you have any questions during installation please call American Car Craft at
727-861-1500. Thank you and enjoy your new purchase.
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com