Do not get wet for 24 hours – American Car Craft Dodge Challenger Taillight Insert Trim Plate Smoked Plexi with Polished Trim 2008-2013 User Manual
Page 2
This three piece kit has been designed to enhance and upgrade the factory taillight area.
Constructed of 304 stainless this kit will look beautiful for years and years without ever
dulling or rusting. This is a simple to install kit that will transform your Challenger
taillight into a nice custom looking tail end.
1. Thoroughly clean the taillight areas to be mounted with alcohol to remove any and all
dirt and or waxes. After this step place a piece of masking tape to see if you have
achieved a tack. If so swipe the areas once with the adhesive promoter pack provided.
2. Before you permanently attach any thing practice placing each section in position and
make note of their correct placement. Make sure that the factory taillight deck lid
section lines up properly with the quarter panel taillight sections. This may require you
to adjust the deck lid stops just under the deck lid so that the three areas line up to each
other perfectly. This step will insure that the new kit will line up properly and offer the
best look.
3. Starting with the larger center section peel the red release liner from the back of the
part and then carefully place into the correct position and then press firmly to set.
NOTE: Be sure that this section is right side up. If you look closely at this section you will
notice that there is a perfectly straight edge. This is the bottom edge and the top edge
has a slight arch to it as does the factory taillight.
4. Now that you have correctly placed the center section, the sides are relatively easy.
Just make sure they ends that meet the center section line up properly as you stick
these two remaining parts into position again press firmly to set. Remove the protective
liner.
DO NOT GET WET FOR 24 HOURS
If you have any questions during installation please call American Car Craft at 727-
861-1500.
Thank you and enjoy your new purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520