American Car Craft HHR Water Tank Cover Polished w_Cap 2006-2012 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
HHR POLISHED WATER TANK COVER
PART#423008
PARTS INCLUDED:
___1-Stainless Water Tank Cover
___1-Decorative Chrome Cap w/attachment cookie
___1- Adhesive Promoter Pack
___1-120NC top hat cap w/putty
You new cover comes to you with a clear protective liner. Do not remove liner until
instructed.
1. Completely remove the factory tank cap and the 10 mm bolt to the left of the tank.
2. Place the new cover over the tank and make any adjustments to the shape if needed to
achieve a nice custom fitted cover.
3. Secure the new cover by replacing the factory nut. Remove the protective liner.
4. Trim off the finger tab and the o- ring strap completely from the factory cap. This can
easily be done with a tin snip. Once this is done, re-install the cap to the tank.
5. You have been provided with a decorative chrome cap cover. To install, scrub the top
of the factory cap with alcohol then swipe the cap once with the adhesive promoter
provided. Remove the attachment cookie half from the under side of the decorative cover
and attach it to the cap you just prepared. Then simply place the decorative cover over the
factory cap to finish the installation.
Note: Care must be taken when cleaning your cover. It is a good idea to lightly dust your
cover with a clean soft cloth first in order to prevent any particles from scratching it.
Then wipe (using a new clean soft cloth) with a good quality streak free glass cleaner.