American Car Craft Mustang BCM Cover Perforated V8 & GT 5.0 2011-2012 - Manual (Page 2)

the left side of the unit. It is this bracket that you will install the additional bracket to which will secure
the new BCM cover.
2. Thoroughly scrub clean the side of the BCM bracket to remove any and all road grime and or dirt. Then
swipe that area with the adhesive promoter provided. This chemical is not a cleaner but an adhesive
accelerator which will insure that the new BCM bracket will attach permanently and securely. Once
you have prepped the area simply peel the red release liner from the back of the new bracket and then
set it directly to the BCM bracket in such a way as to allow the new cover to attach to the Velcro so
that it is level and secure.
3. Now that the new bracket has been properly installed simply remove the release liner from the Velcro
half and then set the new stainless cover so that it makes contact with the Velcro half. Then remove
the new cover so you can further set the Velcro by hand to insure a good and thorough bond. Now
simply remove the protective liner and place the new cover back into position to finish the installation.
If any questions occur during installation please call American Car Craft at 727-861-1500.
Thank you for your purchase!
AMERICAN CAR CRAFT
18924 SAKERA ROAD-HUDSON FLORIDA 34667
Phone # 727-861-1500 Fax # 727-861-1520
www.americancarcraft.com