American Car Craft Corvette Radiator Cover Polished 2005-2007 C6 only User Manual
Page 2
3. You will notice two plastic stud retainers which the factory air tube snaps over.
Although these two retainers appear to be a solid stud that fact is that the top of these
retainers are removable. Simply pull the top of the two retainers upward and completely
out of the lower section. This will expose a sort of square looking hole at the top. You
will use these two holes to secure your new cover.
4. Remove protective liner. Replace radiator cover and align the holes in the new cover
with the holes that you just exposed. You have been supplied with 2 washer head screws,
2 white screw cover bases and 2 chrome screw covers. Using a Philips screw driver pass
one screw thru a white base and install into the first hole. Screw down but do not tighten
yet. Do the same for the second screw. At this time make sure your new cover is lined up
nicely and then tighten both screws, be sure not to over tighten. Snap on the 2 chrome
screw covers.
If any questions occur during installation, please contact American Car Craft at
727-861-1500.
Thank you and enjoy your new purchase.
Note: Care must be taken when cleaning your cover. It is a good idea to lightly dust
your cover with a clean soft cloth first in order to prevent any particles from
scratching it. Then wipe (using a new clean soft cloth) with a good quality streak
free glass cleaner.
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com