American Car Craft Corvette Water Tank Cover Polished w_caps - 2005-2013 C6 Manual Trans. only - Manual (Page 2)

4. Installing the new cover is quite simple. Slide the cover over the top flow tube
then slightly buckle the cover past the water fill neck hole to allow the cover to
insert under the hood gasket ridge as you jostle the cover over the water fill neck
and windshield washer fluid cap neck.
It is critical that the new cover rests under the hood catch not under it. If not you
will damage the new cover, see picture 1a for correct installation.
Picture 1a
5. Your factory windshield washer fluid cap is attached to the neck with a plastic
strap. This strap will need to be trimmed off at the caps base using a common
scissor. You will also need to trim the finger tab from this cap in the same way.
Once this is done simply snap the cap onto the fill neck.