American Car Craft Corvette Plenum_Throttle Body_Radiator Cover 4Pc Designer Series 2005-2007 C6 - Manual (Page 4)

AMERICAN CAR CRAFT INSTRUCTIONS
American Car Craft – 18924 Sakera Rd. Hudson, FL. 34667 – 727.861.1500 – www.AmericanCarCraft.com
7. The next step will be to carefully install the new custom plenum cover. You will notice that the
new cover contains a bracket just under the front U-shaped end. This bracket has been designed
to tuck under the two fuel rail covers, holding the front end of the new cover securely in place
as the Velcro pad toward the rear of the cover will attach securely to the fuel rail, which you
installed earlier. A properly set plenum cover will not touch the molded cover but should have
an even gap of about an eighth of an inch or less all the way around the U-shape and set nicely
along the fuel rails. Remove the protective liner, to finish the installation.
Instructions C6 Corvette 2Pc Radiator Cover
Part #043041
1. Thoroughly clean the top of the factory black plastic radiator cover with household
rubbing alcohol to remove any and all grime and dirt. Then swipe the top back edge of
the factory cover closest to the motor with the adhesive promoter provided.
2. You have been provided with two lengths of Velcro attachment tape. Place the two
lengths directly to the edge of the factory cover you just prepared. Press firmly to set.
Expose the tapes adhesive edge so that the top section of the tape will attach to the new
cover once it is set in position.
3. You will notice a large rubber grommet securing the air tube to the factory radiator cover.
Slide the stainless covers notch directly under the air tubes ear so that it will rest between
the grommet and the air tube. Slide it completely in and set it down so that it will come
into contact with the attachment tape installed earlier and press firmly to set. Lift the
cover off the mounted attachment tape and remove the cover. Firmly press the attachment